LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Manual Transaxle Overhaul - Lancer) >> Sealants And Adhesives >> Surface Preparation

Surface Preparation

WARNING: This page is about a different variant/trim than selected.

Thoroughly remove all substances deposited on the FIPG application surface, using a gasket scraper.

Make sure that the FIPG application surfaces is flat and smooth. Also make sure that the surface is free from oils, greases and foreign substances. Do not fail to remove old FIPG that may remain in the fastener fitting holes.

scientia non olet · About LEMON Manuals