LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Twin Clutch SPORTRONIC Shift Transmission (TC-SST) - With Diagnostics - Lancer (5 Of 6)) >> Diagnosis < Shift Lever > >> Diagnostic Trouble Code Procedures >> DTC U0101: TC-SST Time-out Error >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
  1. STEP 1. Scan tool CAN bus diagnostics 

    Using the scan tool, diagnose the CAN bus lines.

    Q: Is the check result normal? 

    1. YES:  Go to Step 2.
    2. NO:  Repair the CAN bus lines. (Refer to TROUBLESHOOTING .) After repairing the CAN bus line, go to Step 2.
  2. STEP 2. Scan tool diagnostic trouble code 

    Check the TC-SST diagnostic trouble code. (Refer to DIAGNOSTIC TROUBLE CODE TABLE .)

    Q: Is the DTC set? 

    1. YES:  Perform the relevant troubleshooting.
    2. NO:  Go to Step 3.
  3. STEP 3. Check whether the DTC is reset. 

    Q: Is DTC No. U0101 set? 

    1. YES:  Replace the shift lever assembly. (Refer to >> A << TRANSAXLE CONTROL CABLE (TRANSAXLE SIDE/SHIFT LEVER SIDE) INSTALLATION .)
    2. NO:  Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)
scientia non olet · About LEMON Manuals