LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Twin Clutch SPORTRONIC Shift Transmission (TC-SST) - With Diagnostics - Lancer (5 Of 6)) >> Diagnosis < Shift Lever > >> Diagnostic Trouble Code Procedures >> DTC U0100: Engine Time-out Error >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
  1. STEP 1. Scan tool CAN bus diagnostics 

    Using the scan tool, diagnose the CAN bus lines.

    Q: Is the check result normal? 

    1. YES:  Go to Step 2.
    2. NO:  Repair the CAN bus lines. (Refer to TROUBLESHOOTING .) After repairing the CAN bus line, go to Step 2.
  2. STEP 2. Scan tool diagnostic trouble code 

    Check the engine diagnostic trouble code. (Refer to DIAGNOSTIC TROUBLE CODE TABLE .)

    Q: Is the DTC set? 

    1. YES:  Perform the relevant troubleshooting.
    2. NO:  Go to Step 3.
  3. STEP 3. Check whether the DTC is reset. 

    Q: Is DTC No. U0100 set? 

    1. YES:  Replace the shift lever assembly. (Refer to >> A << TRANSAXLE CONTROL CABLE (TRANSAXLE SIDE/SHIFT LEVER SIDE) INSTALLATION .)
    2. NO:  Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)
scientia non olet · About LEMON Manuals