Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.

Q: Is the check result normal?
1. YES: Go to Step 2.
2. NO: Repair the CAN bus lines. (Refer to TROUBLESHOOTING ).
STEP 2. Scan tool diagnostic trouble code
Check the TC-SST diagnostic trouble code. (Refer to DIAGNOSTIC TROUBLE CODE TABLE ).

Q: Is the DTC set?
1. YES: Perform the relevant troubleshooting.
2. NO: Go to Step 3.
STEP 3. ETACS-ECU coding data check.
Check the transaxle coding data stored in ETACS-ECU for any abnormality. (Refer to CODING REFERENCE TABLE ).

Q: Is the check result normal?
1. YES: Go to Step 4.
2. NO: Replace the ETACS-ECU. (Refer to ETACS-ECU ). Then go to Step 5.
STEP 4. Check whether the DTC is reset.
Q: Is DTC No. U0101 set?
1. YES: Replace the AWC-ECU. (Refer to AWC-ECU ). Then go to Step 5.
2. NO: Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).
STEP 5. Check whether the DTC is reset.
Q: Is DTC No. U0101 set?
1. YES: Return to Step 1.
2. NO: This diagnosis is complete.