<< A >> Pull Ring Removal

WARNING: This page is about a different variant/trim than selected.

Pull the pull ring upward as shown in the illustration. (Carry out the following operation with the pull ring pulled upward.)

Fig 1: Pulling Transaxle Control Cable Ring
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Raise the claw using a precision screwdriver.

Fig 2: Removing Claw Using Screwdriver
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Remove the pull ring by turning it clockwise, and pull it out upward.

Fig 3: Removing Pull Ring
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 4: Removing Transaxle Control Cable Ring
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.