LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Twin Clutch SPORTRONIC Shift Transmission (TC-SST) - With Diagnostics - Lancer (6 Of 6)) >> On-Vehicle Service >> ACD Operation Check

ACD Operation Check

WARNING: This page is about a different variant/trim than selected.
CAUTION: Before connecting or disconnecting scan tool, always turn the ignition switch to the LOCK (OFF) position.
  1. Connect scan tool to the data link connector. (Refer to DIAGNOSIS < ACTIVE CENTER DIFFERENTIAL (ACD) > .)
  2. Start the engine.
  3. Position the steering wheel in a straight ahead direction.
  4. Drive the vehicle at 20 km/h (12.4 mph) or less, carry out the scan tool actuator test (item No. 05), and forcibly activate the ACD. Then, turn the steering wheel 180° or more to the right or left, and check that tight corner braking occurs.
    NOTE:
    • The forced activation (item No. 05: ACD operation check mode) is continued for 1 minute, then it will be cancelled automatically. Also, using the clear key on the scan tool, the activation can be forcibly cancelled.
    • When the ACD functions are stopped due to the fail-safe, the forced activation cannot be performed.
    • The occurrence levels of body vibration and noise caused by the tight corner braking phenomenon will differ depending on the conditions of tire and road surface.
    • If the tight corner braking phenomenon does not occur, the system may have an abnormality. Therefore, check the hydraulic pressure.
scientia non olet · About LEMON Manuals