LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Twin Clutch SPORTRONIC Shift Transmission (TC-SST) - With Diagnostics - Lancer (6 Of 6)) >> On-Vehicle Service >> ACD Control Fluid Check >> < When The Scan Tool Is Not Used >

< When The Scan Tool Is Not Used >

WARNING: This page is about a different variant/trim than selected.
  1. Remove the trunk room side trim lid on the right of the trunk room. < LANCER >
  2. If the vehicle has been run, leave it for 90 min. or more in an ordinary temperature {10 - 30°C (50 - 86°F)} to allow the accumulator internal pressure to drop.
    NOTE: If the ambient temperature is 10°C (50°F) or less, allow more time to leave the vehicle to stand idle.
  3. Check that the oil reservoir fluid level is in between MAX and MIN.
  4. If the fluid level is not in between MAX and MIN, fill the specified fluid.

    Brand name: Mitsubishi Motors Genuine ATF SP III 

  5. Install the trunk room side trim lid. < LANCER >
    Fig 1: Identifying Oil Reservoir (Lancer)
    G07031783Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals