LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Twin Clutch SPORTRONIC Shift Transmission (TC-SST) - With Diagnostics - Lancer (6 Of 6)) >> MECHATRONIC Assembly, Manual Control Lever >> Removal And Installation >> Removal Service Points >> << B >> Plug/Bolt/Manual Control Shaft Removal

<< B >> Plug/Bolt/Manual Control Shaft Removal

WARNING: This page is about a different variant/trim than selected.
  1. Move the lever from D in clock direction to the service position as shown.
    Fig 1: Locating Control Shaft Lever Position
    G06471488Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Remove the plug.
    Fig 2: Identifying Control Shaft Plug
    G06471489Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    CAUTION: When removing bolt, use magnetic tools to prevent them from falling out.
  3. When removing the bolt located behind the plug, pay attention to the bolt not to fall in the transaxle case.
  4. Remove the manual control shaft carefully.
    Fig 3: Identifying Control Shaft Bolt
    G06471490Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals