<< C >> Engine And Transaxle Assembly Holding

WARNING: This page is about a different variant/trim than selected.

Install a special tool for holding the engine and transaxle assembly.

< Special tool MB991928 is used >
1. Assemble the special tool MB991928. Set the following parts on the base hanger.
  - Slide bracket (HI)
  - Foot x 4 (standard) (MB991932)
  - Joint x 2 (90) (MB991930)
2. Set the foot of the special tool as shown in the figure.
  NOTE: Slide the slide bracket (HI) to adjust the engine hanger balance.
  
  Fig 1: Supporting Engine And Transaxle Assembly
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Mount special tool MB991454 to the power steering oil pump bracket and engine hanger, and set it to special tool MB991928 to support the engine and transaxle assembly.
  
  Fig 2: Identifying Special Tool MB991928 And MB991454
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
< Special tool MB991895 is used >
1. Set the foot of special tool MB991895 as shown in the figure.
  NOTE: Slide the foot to adjust the engine hanger balance.
  
  Fig 3: Identifying Special Tool MB991895
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Mount special tool MB991454 to the power steering oil pump bracket and the engine hanger, and set it to special tool MB991895 to support the engine and transaxle assembly.
  
  Fig 4: Identifying Special Tool MB991454 And MB991895
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.