Special Tools

WARNING: This page is about a different variant/trim than selected.

Tool number and name	Supersession	Application
MB992080 Belt tension meter set MB9912081 Belt tension meter MB992082 Microphone assembly	Tool not available	Drive belt tension (frequency) measurement
MB991958 Scan tool (M.U.T.-III sub assembly) MB991824 Vehicle communication interface (V.C.I.) MB991827 M.U.T.-III USB cable MB991910 M.U.T.-III main harness A (Vehicles with CAN communication system) MB991911 M.U.T.-III main harness B (Vehicles without CAN communication system) MB991914 M.U.T.-III main harness C (for Chrysler models only) MB991825 M.U.T.-III adapter harness MB991826 M.U.T.-III trigger harness	MB991824-KIT NOTE: MB991826 M.U.T.-III Trigger Harness is not necessary when pushing V.C.I. ENTER key.	CAUTION: For vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly. Ignition timing check Curb idle speed check Idle mixture check Erasing the diagnostic trouble code
MB992278 Belt tension release wrench	-	Auto-tensioner tension release
MB990767 Front hub and flange yoke holder	MB990767-01	Holding the crankshaft pulley
MD998719 Pin	MIT308239	Holding the crankshaft pulley
MB992103 Chain tension release bar	-	Camshaft and camshaft sprocket assembly (exhaust side) removal
MD998772 Valve spring compressor	General service tool	Valve spring compression
MB992090 Retainer holder attachment	-
MB992089 Retainer holder C	-
MB992085 Valve stem seal pliers	-	Valve stem seal removal
MD998737 Valve stem seal installer	MD998737-01	Valve stem seal press-fitting
MD998727 Oil pan FIPG cutter	MD998727-01	Engine oil pan removal
MB991883 Flywheel stopper	General service tool	Supporting the flywheel < M/T > or drive plate < CVT >
MD998718 Crankshaft rear oil seal installer	MD998718-01	Press-fitting the crankshaft rear oil seal
MB991448 Bush remover and installer base	MB991448-01	Press-fitting the crankshaft front oil seal
MB991614 Angle gauge	-	Balancer shaft and oil pump module installation
MB991928 Engine hanger MB991929 Joint (50) x 2 MB991930 Joint (90) x 2 MB991931 Joint (140) x 2 MB991932 Foot (standard) x 4 MB991933 Foot (short) x 2 MB991934 Chain and hook assembly	Tool not available	Supporting the engine assembly NOTE: Special tool MB991454 is a part of engine hanger attachment set MB991453.
MB991895 Engine hanger	Tool not available
MB991527 Hanger	Tool not available
MB992201 Engine hanger plate	-
MB991454 Engine hanger balancer	MZ203827-01