<< B >> Engine Oil Pan Removal

WARNING: This page is about a different variant/trim than selected.

Remove the engine oil pan mounting bolts.
CAUTION: Do not forcibly drive in special tool MD998727 to avoid damage to the engine oil pan seal surface of cylinder block assembly.
Insert special tool MD998727 from the engine oil pan removal groove of the cylinder block assembly.
Lightly tap the special tool MD998727 with a hammer to slide the engine oil pan seal surface, cut off the liquid gasket, and remove the engine oil pan.

Fig 1: Locating Groove Of Cylinder Block Assembly (Front)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Locating Groove Of Cylinder Block Assembly (Rear)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Tapping Special Tool MD998727
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.