LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L - Lancer) >> Engine Assembly >> Removal And Installation >> Removal Service Points >> << B >> Fuel High-Pressure Hose Disconnection

<< B >> Fuel High-Pressure Hose Disconnection

WARNING: This page is about a different variant/trim than selected.
  1. Remove the stopper of the fuel high-pressure hose.
    Fig 1: Removing Stopper Of Fuel High-Pressure Hose
    G05374170Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Raise the retainer of the fuel high-pressure hose and pull out the fuel high-pressure hose in the direction shown in the figure.
    NOTE: If the retainer is released, install it securely after removing the fuel high-pressure hose.
    Fig 2: Raising Retainer Of Fuel High-Pressure Hose
    G05374171Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals