LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L - Lancer) >> Cylinder Head Gasket >> Removal And Installation >> Removal Service Points >> << C >> Front Camshaft Bearing Cap Removal

<< C >> Front Camshaft Bearing Cap Removal

WARNING: This page is about a different variant/trim than selected.
  1. Temporarily install the engine oil pan which was removed at the timing chain removal (Refer to TIMING CHAIN  .)
    CAUTION: When supporting the engine and transaxle assembly with a garage jack, be careful not to deform the engine oil pan.
  2. Place a garage jack against the engine oil pan with a piece of wood in between to support the engine and transaxle assembly.
  3. Remove special tool MB991454, MB991928 or MB991895 which was installed for supporting the engine and transaxle assembly when the timing chain was removed.
    Fig 1: Identifying Special Tool MB991928 And MB991454
    G05374174Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Identifying Special Tool MB991454 And MB991895
    G05374175Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    CAUTION: Be careful not to drop the camshaft bearing.
  4. Loosen the front camshaft bearing cap mounting bolts in the order of number shown in the figure, and remove the front camshaft bearing cap.
    Fig 3: Front Camshaft Bearing Caps Mounting Bolts Loosening Sequence
    G05901968Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals