>> A << Crankshaft Pulley/Crankshaft Pulley Washer/Crankshaft Pulley Center Bolt Installation

WARNING: This page is about a different variant/trim than selected.

Wipe off the dirt on the crankshaft and crankshaft pulley as shown in the figure using a rag.
Wipe off the dirt on the crankshaft sprocket, crankshaft and crankshaft pulley as shown in the figure using a rag, and then degrease them.
NOTE: Degrease them to prevent drop in the friction coefficient of the pressed area, which is caused by oil adhesion.
Install the crankshaft pulley.
Wipe off the dirt on the crankshaft pulley washer and crankshaft pulley center bolt as shown in the figure using a rag.
Apply an adequate and minimum amount of engine oil to the threads of the crankshaft pulley center bolt and lower area of the flange.

Fig 1: Applying Engine Oil To Threads Of Crankshaft Pulley Center Bolt
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Hold the crankshaft pulley with special tools MB990767 and MD998719 in the same manner as removal.
Tighten the crankshaft pulley center bolt to the specified torque.
Tightening torque: 210 N.m (155 ft-lb)

Fig 2: Holding Crankshaft Drive Sprocket Using Special Tools MB990767 And MD998719
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.