>> B << Drive Plate < CVT >/Adapter Plate < CVT >/Drive Plate Bolt < CVT >/Flywheel Assembly < M/T >/Flywheel Bolt < M/T > Installation

WARNING: This page is about a different variant/trim than selected.

Remove the sealant, engine oil, and other adhering materials from the drive plate installation face, the crankshaft screw hole and drive plate bolts < CVT. >
Remove the sealant, engine oil, and other adhering materials from the flywheel assembly installation face, the crankshaft screw hole and flywheel bolts < M/T. >
Install the drive plate and drive plate adapter plate to the crankshaft < CVT. >
Install the flywheel assembly to the crankshaft < M/T. >
Use special tool MB991883 to secure the drive plate in the same manner as removal < CVT. >
Use special tool MB991883 to secure the flywheel assembly in the same manner as removal < M/T. >
Apply a small amount of engine oil to the screw holes of the crankshaft and the bearing surface of the drive plate bolts < CVT. >
Apply a small amount of engine oil to the screw holes of the crankshaft and the bearing surface of the flywheel bolts < M/T. >

Fig 1: Fixing Flywheel Assembly Or Drive Plate Using Flywheel Stopper
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Apply specified sealant to the drive plate bolts < CVT > or flywheel bolts < M/T > threads.
Specified sealant: ThreeBond 1324

Fig 2: Identifying Sealant Applying Area On Drive Plate Bolts
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Tighten the drive plate bolts < CVT > or flywheel bolts < M/T > to the specified torque in the order shown in the illustration.
Tightening torque: 40 N.m (30 ft-lb)
Tighten the drive plate bolts < CVT > or flywheel bolts < M/T > to the specified torque again in the order shown in the illustration.
Tightening torque: 130 N.m (96 ft-lb)

Fig 3: Drive Plate/Flywheel Bolt Tightening Sequence
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.