LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L - Lancer) >> Crankshaft Oil Seal >> Removal And Installation >> Installation Service Points >> >> A << Crankshaft Rear Oil Seal Installation

>> A << Crankshaft Rear Oil Seal Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply a small amount of engine oil to the entire inner diameter of the crankshaft rear oil seal lip.
  2. Using special tool MD998718, press in the crankshaft rear oil seal up to the cylinder block end surface.
    Fig 1: Identifying Engine Oil Applying Area On Inner Diameter Of Crankshaft Rear Oil Seal Lip
    G05902010Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals