LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L - Lancer) >> Balancer Timing Chain, Balancer Shaft And Oil Pump Module >> Removal And Installation >> Installation Service Points >> >> B << Timing Chain TENSIONER Installation

>> B << Timing Chain TENSIONER Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the timing chain tensioner to the cylinder block.
  2. Remove the hard wire or L-shaped hexagon wrench fixing the plunger of the timing chain tensioner to apply tension to the balancer timing chain.
    Fig 1: Fixing Plunger Of Timing Chain Tensioner Using Hard Wire/L-Shaped Hexagon Wrench
    G05425778Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals