<< D >> LJ Assembly Removal

WARNING: This page is about a different variant/trim than selected.

Remove the LJ boot from the LJ assembly.

Fig 1: Identifying LJ Assembly And Boot
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Make mating marks on the outer race, cage and inner race, and then remove the outer race and ball.
NOTE: Note the positions of the balls so that they can be reinstalled in their original positions.

Fig 2: Identifying Propeller Shaft Inner, Outer Race, Cage And Ball
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Remove the inner race with cage from the rear propeller shaft assembly by using a puller (commercially available).
Wipe off the grease and clean the outer race, inner race, cage and balls.

Fig 3: Removing Inner Race From Rear Propeller Shaft Assembly By Using Puller
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If it is not possible to disassemble the outer race of LJ assembly, remove the LJ assembly from the rear propeller shaft assembly by using a puller (commercially available).

Fig 4: Disassembling LJ Assembly Outer Race
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.