LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Propeller Shaft - Lancer RALLIART, Se) >> Propeller Shaft >> Disassembly And Assembly < RALLIART > >> Assembly Service Points >> >> D << Center Bearing Assembly/Companion Flange/Self Locking Nut Installation

>> D << Center Bearing Assembly/Companion Flange/Self Locking Nut Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the center bearing assembly to the center propeller shaft in the direction shown in the illustration.
  2. After aligning the mating marks of the companion flange and center propeller shaft, install them.
  3. Tightening the self locking nut, press fit the center bearing assembly using companion flange.
    Fig 1: Identifying Center Bearing Assembly, Companion Flange And Self Locking Nut
    G07029410Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals