LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Propeller Shaft - Lancer RALLIART, Se) >> On-Vehicle Service >> Propeller Shaft Universal Joint Check >> Propeller Shaft Universal Joint Flection Check

Propeller Shaft Universal Joint Flection Check

WARNING: This page is about a different variant/trim than selected.
  1. Place the gearshift lever to the "N" position < TC-SST > or the selector lever to the "N" position < CVT >.
  2. Then place the drive mode selector to the "2WD" position < Type B >.
  3. Make phase alignment marks on the flange yoke and differential companion flange and disconnect the flange yoke.
  4. Hold the tube of propeller shaft by one hand, and apply force by the other hand to the flange yoke in flection direction for checking flection. If showing a sign of catch in the flection direction is recognized, replace the propeller shaft with a new one.
    Fig 1: Checking Propeller Shaft Universal Joint Flection
    G06482445Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals