<< B >> Engine Oil Pan Removal

WARNING: This page is about a different variant/trim than selected.

Remove the engine oil pan mounting bolts.
CAUTION: Do not forcibly drive in special tool MD998727 to avoid damage to the engine oil pan seal surface of cylinder block assembly.
Insert special tool MD998727 to the engine oil pan removal groove of the cylinder block assembly.
Lightly tap the special tool MD998727 with a hammer to slide the engine oil pan seal surface, cut off the liquid gasket, and remove the engine oil pan.

Fig 1: Identifying Engine Oil Pan Groove And Crankshaft Pulley
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Engine Oil Pan Groove And Engine Oil Filter
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Tapping Special Tool With Hammer
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.