LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L Turbo - Lancer) >> Oil Pan >> Removal And Installation >> Installation Service Points >> >> A << Engine Oil Pan Installation

>> A << Engine Oil Pan Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove all the traces of sealant adhering to the engine oil pan and cylinder block assembly using a remover or others. Then, degrease them.
  2. Apply the sealant without any gap to the mating surface of engine oil pan as shown in the figure, and install the engine oil pan to the cylinder block assembly.

    Specified sealant: ThreeBond 1227D or equivalent 

    NOTE: Install the engine oil pan immediately after applying sealant.
    CAUTION: After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the oil or water to the sealant application area or start the engine.
    Fig 1: Identifying Engine Oil Pan Sealant Application Area
    G05898958Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Tighten the engine oil pan mounting bolts to the specified torque.

    Tightening torque: 

    M6: 10 ± 2 N.m (89 ± 17 in-lb) 

    M8: 29 ± 2 N.m (22 ± 1 ft-lb) 

scientia non olet · About LEMON Manuals