>> B << Flywheel/Flywheel Hub/Flywheel Bolt Installation

WARNING: This page is about a different variant/trim than selected.

Remove the sealant, the engine oil, and other adhering materials from the flywheel bolt threads, crankshaft tapped hole, and flywheel.
Install the flywheel and flywheel hub to the crankshaft.
Use special tool MB991883 to secure the flywheel in the same manner as removal.
Apply a small amount of engine oil to the screw holes of the crankshaft and the bearing surface of the flywheel bolts.

Fig 1: Fixing Flywheel Using Special Tool MB991883
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Apply sealant to the thread of the flywheel bolts.
Specified sealant: ThreeBond 1324

Fig 2: Locating Flywheel Bolts Thread Sealant Application Area
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Tighten the flywheel bolts to temporary torque in the order shown in the illustration.
Tightening torque: 40 N.m (30 ft-lb)
Tighten the flywheel bolts to specified torque in the order shown in the illustration.
Tightening torque: 130 N.m (96 ft-lb)

Fig 3: Flywheel Bolt Tightening Sequence
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.