Inspection Procedure 5: DIAGNOSIS MODE cannot be made an entry. Mobile Phone item is not displayed on the MENU screen of audio. < Vehicles with radio and CD player >: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Required Special Tools:

MB991223: Harness Set
MB992006: Extra Fine Probe

STEP 1. Check the radio and CD player operation.
Check if the radio and CD player work normally and the sound is output.

Q: Is the check result normal?
- YES: Go to Step 2
- NO: Troubleshoot the radio and CD player. (Refer to TROUBLE SYMPTOM CHART .)
STEP 2. Check of short to power supply, short to ground, and open circuit in IE+, IE- line between hands free module connector and radio and CD player connector.
Q: Is the check result normal?
- YES: Go to Step 3
- NO: Repair the connector(s) or wiring harness.
STEP 3. Check if the power supply circuit of hands free module have a problem.
Perform the INSPECTION PROCEDURE 1 "CHECK THE HANDS FREE MODULE POWER SUPPLY CIRCUIT." of the troubleshooting.

Q: Is the check result normal?
- YES: Go to Step 4
- NO: Repair according to the troubleshooting for reference.
STEP 4. Replace the hands free module temporarily, and check the trouble symptom.
Q: Is the check result normal?
- YES: Replace the hands free module.
- NO: Replace the radio and CD player.