LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Hands Free Module) >> On-Vehicle Service >> Methods For Pairing And Pairing Deletion With BLUETOOTH® Device < Using Steering Wheel Remote Control Switch > >> Pairing Method

Pairing Method

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to "ACC" or "ON" position.
  2. Press the "SPEECH" switch.
  3. Say "Setup."
  4. Say "Pairing options."
  5. The voice guide will say "Select one of the following: pair, edit, delete, or list?"
  6. Say "Pair."
  7. The voice guide will say "Please say a 4-digit pairing code."
  8. Say a 4 digit number. The 4 digit number will be registered as a pairing code for the device.
    • When the confirmation function is on, the system will confirm whether the number said is acceptable. Answer "Yes" to go Step 8. Say "No" to return to pairing code selection.
      NOTE:
      • The pairing code entered here is only used for the Bluetooth® connection certification. It is any 4-digit number the user would like to select. A predetermined 4-digit number may be assigned to some Bluetooth® devices.
      • Remember the pairing code as it needs to be keyed into the device later in the pairing process.
      • Depending on the connection settings of the Bluetooth® device, this code may have to be entered each time you connect the Bluetooth® device to the hands free module. For the default connection settings, refer to the instructions for device.
  9. The voice guide will say "Start pairing procedure on device. See device manual for instructions." Refer to the owner's manual for your device and enter into the device the pairing code that was registered in Step  7.
  10. When this system finds a Bluetooth® device, the voice guide will say "Please say the name of the device after the beep."
  11. After you hear the beep, name the device by saying a name of your preference.
    NOTE: When the confirmation function is on, after repeating the device tag you have said, the voice guide will ask "Is this correct?" Answer "Yes".
    To change the device tag, answer "No" and then say the device tag again.
  12. The voice guide will say "Pairing complete," after which a beep will be played and the pairing process will end.
scientia non olet · About LEMON Manuals