Diagnostic Procedure
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Scan tool CAN bus diagnostics
Using the scan tool, diagnose the CAN bus lines.
Q: Is the check result normal?
YES : Go to Step 2.
NO : Repair the CAN bus lines. (Refer to TROUBLESHOOTING ). After repairing the CAN bus line, go to Step 2.
- STEP 2. Scan tool diagnostic trouble code
Check the shift lever diagnostic trouble code. (Refer to DIAGNOSTIC TROUBLE CODE CHART ).
Q: Is the DTC set?
YES : Perform the relevant troubleshooting.
NO : Go to Step 3.
- STEP 3. Check whether the DTC is reset.
Q: Is DTC No. U0103 set?
YES : Replace the TC-SST assembly. (Refer to TRANSAXLE ASSEMBLY ).
NO : Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).