Diagnostic Procedure
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.
Q: Is the check result normal?
YES : Go to Step 3.
NO : Repair the CAN bus lines. (Refer to TROUBLESHOOTING ). After repairing the CAN bus line, go to Step 2.
- STEP 2. Check whether the DTC is reset.
Q: Is DTC No. P0563 set?
YES : Go to Step 3.
NO : This diagnosis is complete.
- STEP 3. Generator system check
Refer to ON-VEHICLE SERVICE .
Q: Is the check result normal?
YES : Go to Step 4.
NO : Repair or replace the generator related parts.
- STEP 4. Check whether the DTC is reset.
Q: Is DTC No. P0563 set?
YES : Shift lever assembly replacement. (Refer to TRANSMISSION CONTROL ).
NO : Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).