External Device Connection Check

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Select "Ext. Device Conn. Check" button on "Unit Diagnosis" screen.

Fig 1: Display Unit Diagnosis Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
"Now checking the external device connection." will appear, and then it will switch to "External Device Connection Result" screen.
- If the connection with an equipment is detected, "OK" will be displayed.
- If the connection with an equipment is not detected, "--" will be displayed.
- In case other than above, "NG" is displayed.
  
  Fig 2: Display Checking Screen For External Device Connection Result
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  
  Fig 3: Display External Device Connection Result Screen
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If "NG" is displayed on the check result screen, "NG code" will be displayed by pressing the respective button on "External Device Connection Result" screen.
NOTE: If "NG" is not displayed at all, "NG code" button is not active.

Fig 4: Display NG Codes Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.