LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Liftgate - Vehicles Without Power Liftgate) >> On-Vehicle Service >> Liftgate Alignment >> Adjustment Of Engagement Between Striker And Latch

Adjustment Of Engagement Between Striker And Latch

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear end trim (Refer to INTERIOR TRIMS ).
  2. Replace the striker mounting screws with temporary bolts, and use the remover bar (special tool: MB990939) and a hammer to tap the temporary bolt to the desired direction.
  3. Tighten the striker mounting screws.

    Tightening torque: 22 ± 3 N.m (16 ± 2 ft-lb) 

  4. Install the rear end trim (Refer to INTERIOR TRIMS ).
    Fig 1: Tightening Striker Temporary Bolts
    G09666184Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals