Door Window Glass Adjustment

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Check that a door window glass operates smoothly and moves along the door window glass runchannel when the window glass is fully raised and lowered. If there is a problem, adjust the window glass by the following procedures:

Remove a door trim assembly (Refer to DOOR TRIM ).
Remove a waterproof film (Refer to REMOVAL AND INSTALLATION ).
Remove the door speaker bracket (Front door) < Vehicles with audio amplifier > (Refer to < VEHICLES WITH DISPLAY AUDIO > ).
Remove the door speaker cover (Rear door) < Vehicles with audio amplifier > (Refer to < VEHICLES WITH DISPLAY AUDIO > ).
Remove the power window switch from the removed door trim assembly, and connect it to the door side connector.
Set the channel guide mounting bolts to the adjusting hole.
Raise the window glass with the power window switch to check that the window glass to door clearance is even. If there is a problem, loosen the channel guide mounting bolts to adjust tilting up/down of the glass.

Fig 1: Identifying Door Speaker Bracket Mounting Hole, Channel Guide Mounting Bolts (Front Door)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Door Speaker Bracket Mounting Hole, Channel Guide Mounting Bolts (Rear Door)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.