Transmission Oil Change

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
Remove the oil drain plug and gasket to drain the oil.
Install the oil drain plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 N.m (24 ± 2 ft-lb)

Fig 1: Identifying Oil Filler Plug
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Remove the oil filler plug and gasket, then fill the oil up to the lower edge of the oil filler plug.
Brand name: Mitsubishi genuine Dia-Queen New Multi Gear Oil SAE 75W-80 API GL-3

Quantity: 2.5 dm ³ (2.6 quarts)

Fig 2: Checking Oil Level
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the oil filler plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb)
Install the engine room under cover front B assembly. (Refer to UNDER COVER .)