LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Manual Transaxle On-Vehicle Service - Lancer Evolution) >> On-Vehicle Service >> Transfer Oil Change

Transfer Oil Change

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
  2. Remove the oil drain plug and gasket to drain the oil.
  3. Install the oil drain plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

    Fig 1: Identifying Oil Filler Plug, Oil Drain Plug And Engine Oil Pan
    G05392273Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Remove the oil filler plug and gasket, then fill the oil up to the lower edge of the oil filler plug hole.

    Brand name: Mitsubishi genuine Dia-Queen LSD Gear Oil 

    Quantity: 0.8 dm 3  (0.9 quarts) 

    Fig 2: Identifying Oil Filler Plug
    G05393892Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install the oil filler plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  6. Install the engine room under cover front B assembly. (Refer to UNDER COVER .)
scientia non olet · About LEMON Manuals