LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Window Glass) >> Quarter Window Glass >> Removal And Installation >> Installation Service Points >> >> A << Fastener/Clip Installation

>> A << Fastener/Clip Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the quarter window glass assembly is reused, follow the procedures below:
    1. Engage the clip with the body.
    2. Cut off the convex portion of the quarter window glass assembly clip installation position.
      NOTE: If the quarter window glass assembly is installed without cutting off the convex portion of the quarter window glass assembly clip installation position, improper installation may result.
    CAUTION: Before the next operation, leave the decreased parts for 3 minutes or more to dry. Do not touch the degreased parts.
    Fig 1: Cutting Off Convex Portion Of Quarter Window Glass Assembly Clip Installation Position
    G09666115Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Use parts cleaner (3M™ AAD Part number 8906 or equivalent) to degrease the inside circumference of the quarter window glass assembly and the body flanges.
  3. Install the fasteners to the specified positions on the body flange.
  4. Install the fasteners to the quarter window glass assembly at the positions which correspond to the fasteners on the body flange.
    Fig 2: Identifying Quarter Window Glass Assembly Fasteners Installation Dimension
    G09666116Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals