Lin (Lighting Control Sensor)
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
| Item No. | M.U.T.-III display | Check condition | Normal condition |
|---|---|---|---|
| 7005 | RLS rain sensor ON/OFF | When wiper switch is in any position other than AUTO | OFF |
| When wiper switch is in AUTO position | ON | ||
| 7006 | RLS rain sensor sensitivity | Changes from 1 to 6 according to the wiper volume. | 1,2,3,4,5,6 |
| 7008 | RLS wiper auto stop SW | Windshield wipers are in operation. | Other than Park position |
| Other than above | Park position | ||
| 7013 | RLS wiper control output | No operation request is received from lighting control sensor (rain sensor). | OFF |
| LO operation request is received from lighting control sensor (rain sensor). | Lo | ||
| HI operation request is received from lighting control sensor (rain sensor). | Hi | ||
| 7020 | RLS RS measurement value (RS1) | Lighting control sensor (rain sensor) detects rain drops. | The value changes when sensor 1 detects rain drops. |
| 7021 | RLS RS measurement value (RS2) | Lighting control sensor (rain sensor) detects rain drops. | The value changes when sensor 2 detects rain drops. |
| 7022 | RLS RS adaptation value (RS1) | Initializing after adaptation (Sensor 1) | Output amount when initializing (Sensor 1) |
| 7023 | RLS RS adaptation value (RS2) | Initializing after adaptation (Sensor 2) | Output amount when initializing (Sensor 2) |
| 7024 | RLS RS adaptation gain level | Initializing after adaptation | The calibrated value of initializing |