Trailing Arm Bushing Replacement

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Use the following special tools to remove the trailing arm bushing:
- Arm bushing remover and installer (MB992523)
- Spacer base (MB992865)
- Arm bushing base (MB992125)
  
  Fig 1: Removing Trailing Arm Bushing
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Determine the installation direction and the installation position of the trailing arm bushing.
1. Install so that the protruding side of the trailing arm bushing inner pipe faces inside the body.
2. Position horizontally the trailing arm bushing to body connecting part, and locate bushing inner space as shown in the figure.
  
  Fig 2: Identifying Bushing Inner Space Dimension
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Use the following special tools to press-fit the trailing arm bushing up to the position shown in the figure:
- Arm bushing remover and installer (MB990890)
- Spacer base (MB992865)
- Arm bushing base (MB992125)
  
  Fig 3: Installing Arm Bushing
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.