<< D >> Rear Wheel Hub Assembly Removal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

If the rear wheel hub assembly is seized with the rear driveshaft assembly, use the following special tools to push the rear driveshaft assembly out from the hub and then remove the rear wheel hub assembly.
- Puller shaft (MB990242)
- Puller bar (MB990244)
- Puller body (MB991354)
- Front hub and flange yoke holder (MB990767)
  
  Fig 1: Removing Rear Wheel Hub Assembly
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If the rear wheel hub assembly is seized with the trailing arm, use the following special tools to remove the rear wheel hub assembly.
Combination (A)
- Slide hammer (MB990211)
- Rear axle shaft puller (MB990241)
  Combination (B)
- Slide hammer (MB990211)
- Puller body (MB991354)
  
  Fig 2: Removing Rear Wheel Hub Assembly - Combination (A)
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  
  Fig 3: Removing Rear Wheel Hub Assembly - Combination (B)
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.