>> A << Engine Mounting Bracket Installation
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not remove small tapping screw.
Tighten the engine mounting bracket mounting bolts by the following procedure.
| Order |
Bolt |
Tightening torque |
| 1st |
A |
Approximately 0 - 5.0 N.m (0 - 44 in-lb) |
| 2nd |
B |
50 ± 5 N.m (37 ± 3 ft-lb) |
| 3rd |
A |
50 ± 5 N.m (37 ± 3 ft-lb) |
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.