LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Wheel & Tire - With Diagnostics) >> Wheel And Tire Diagnosis >> Wheel Balance Accuracy >> PROCEDURE Balancing Tips

PROCEDURE Balancing Tips

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Confirm that the balancer's cone and the wheel mounting cone are undamaged and free of dirt and rust.
  2. On this vehicle, the wheel's center hole on the hub side has a chamfered edge. Use a back-mounting cone on your wheel balancer to center the wheel on the balancer shaft.
  3. Install a wheel mounting cone. The appropriate size cone for this vehicle is 67.0 mm (2.64 inches).
  4. Before balancing the wheel, remove any wheel weights from both sides. Also check both sides for any damage.
  5. When installing wheel weights, hammer them at a straight (not diagonal) angle.
scientia non olet · About LEMON Manuals