<< C >> Seal Washer/Valve Removal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Remove the seal washer to prevent scratching the valve of the TPMS transmitter.

Hold the TPMS transmitter and the seal washer, then extract the seal washer. Take care to not damage the valve thread.

Fig 1: Holding TPMS Transmitter And Seal Washer
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Clean the TPMS transmitter and the valve stem. < In case of not removing the valve >
NOTE: If the valve comes out from transmitter, install it to where it was. (This is not failure)

Fig 2: Cleaning TPMS Transmitter And Valve Stem
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Removal the valve from housing as shown.

Fig 3: Removing Valve From Housing
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.