Special Tools
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
| Tool | Tool number and name | Supersession | Application |
|---|---|---|---|
| MB992113 Drive pinion holder | - |
|
|
| MB991618 Hub bolt remover | General service tool | Hub bolt removal | |
| MB990767 Front hub and flange yoke holder | MB990767-01 | Hub fixing | |
| MB992700 Lock nut chisel | General service tool | Raising up the swaged part driveshaft nut | |
| MB991115 Oil seal installer | MB991115-01 | Oil seal press-fitting (used in combination with MB990938) | |
MB990925 Bearing and oil seal installer set
|
MB990925-01 or General service tool |
|
|
| MB990241 Axle shaft puller
|
MB990241-01 or General service tool |
|
|
| MB991354 Puller body |
General service tool | ||
| MB990211 Slide hammer |
General service tool | Rear hub assembly removal | |
A, B: Front hub remover and installer C: Spacer |
MB990998-01 |
|
|
| MB990326 Preload socket |
General service tool | Hub rotation torque measurement | |
| MB990685 Torque wrench |
General service tool | ||
| MB990909 Working base |
General service tool | Differential carrier assembly disassembly/assembly | |
| MB991116 Working base adapter |
General service tool | ||
| MB992111 Side bearing holder |
- | Differential carrier fixing | |
| MB990810 Side bearing puller |
MB990810-01 | Differential side bearing inner race removal | |
| MB992112 Locking nut wrench |
- | Differential nut removal | |
| MB990560 Rear axle shaft bearing remover |
MD998348-01 | Drive pinion rear bearing inner race removal | |
| MB992114 Dummy pinion gauge assembly
|
- | Drive pinion height adjustment | |
| MB992117 Cylinder gauge |
General service tool | ||
| MD998816 Bearing installer |
- | Drive pinion rear bearing inner race press-fitting | |
| MB991180 Bushing remover and installer base |
- | Drive pinion oil seal press-fitting | |
| MB990829 Pinion and side bearing installer |
- | Side bearing inner race press-fitting |
BEARING AND OIL SEAL INSTALLER SET SPECIFICATION
| Tool | Type | Number | O D mm (in) |
|---|---|---|---|
| A | MB990926 | 39.0 (1.54) | |
| MB990927 | 45.0 (1.77) | ||
| MB990928 | 49.5 (1.95) | ||
| MB990929 | 51.0 (2.00) | ||
| MB990930 | 54.0 (2.13) | ||
| MB990931 | 57.0 (2.24) | ||
| MB990932 | 61.0 (2.40) | ||
| MB990933 | 63.5 (2.50) | ||
| MB990934 | 67.5 (2.66) | ||
| MB990935 | 71.5 (2.81) | ||
| MB990936 | 75.5 (2.97) | ||
| MB990937 | 79.0 (3.11) | ||
| B | MB990938 | - | |
| C | MB990939 | - |