<< B >> Driveshaft Nut Removal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Make sure that the lock nut chisel is set in the correct direction. Otherwise, the groove or thread in the driveshaft may be broken, or the tip of the chisel may be chipped.
Never use a chisel which tip is damaged.
For how to use the lock nut chisel, refer to the manufacturer's operating instructions.

Set the special tool lock nut chisel (MB992700) in the groove of the driveshaft with its "UPPER" mark facing upwards. Then strike the staked portion of the driveshaft nut with the chisel and a hammer to raise up.

Fig 1: Installing Special Tool Lock Nut Chisel (MB992700) On Groove Of Driveshaft
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CAUTION: Be careful not to damage the thread of the driveshaft.
Raise up the staked portion of the driveshaft nut until it does not interfere with the shaft thread.
CAUTION:
- Never use a impact wrench to loosen the driveshaft nut.
- Do not apply the vehicle weight on the wheel bearing with the driveshaft nut loosened. Otherwise, the wheel bearing may be broken.
Fig 2: Identifying Raise Up Staked Portion Of Driveshaft Nut
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Use special tool front hub and flange yoke holder (MB990767) to counter the hub, and remove the driveshaft nut.

Fig 3: Driving Driveshaft Nut
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.