LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Rear Axle - AWD) >> On-Vehicle Service >> Wheel Bearing End Play Check

Wheel Bearing End Play Check

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caliper assembly and the brake disc. Retain the caliper assembly with a wire and the like to prevent from falling.
  2. Set a dial gauge as shown in the figure. Move the hub in the axial direction and measure the looseness.

    Limit: 0.05 mm (0.002 inch) 

  3. When the looseness exceeds the limit, replace the rear wheel hub assembly.
  4. After checking, install the brake disc and the caliper assembly, and tighten the caliper mounting bolt to the specified torque.

    Tightening torque: 58 ± 7 N.m (43 ± 5 ft-lb) 

    Fig 1: Checking Wheel Bearing End Play
    G09665737Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals