Hub Bolt Replacement

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Required Special Tools:

MB991618: Hub bolt remover
MB990767: Flange yoke holder

Remove the caliper assembly and the brake disc. Retain the caliper assembly with a wire and the like to prevent from falling.
Use special tool hub bolt remover (MB991618) to remove the hub bolt.

Fig 1: Removing Hub Bolt Using Special Tool Hub Bolt Remover (MB991618)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
After fixing the hub using special tool front hub and flange yoke holder (MB990767), install the plain washer to the new hub bolt, and tighten the bolt with a nut.
Install the brake disc, caliper assembly and tighten the caliper assembly mounting bolts to the specified torque.
Tightening torque: 58 ± 7 N.m (43 ± 5 ft-lb)

Fig 2: Tightening Caliper Assembly Mounting Bolts
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.