Differential Carrier Oil Seal Replacement
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
Required Special Tools:
- MB990938: Installer bar
- MB991115: Oil seal installer
- Remove the driveshaft (Refer to DRIVESHAFT ASSEMBLY ).
- Remove the differential carrier oil seal.
- Use the following special tools to drive in the oil seal:
- Installer bar (MB990938)
- Oil seal installer (MB991115)
- Coat the oil seal lip and the oil seal contact surface on the driveshaft with the multi-purpose grease.
- Replace the driveshaft circlip with a new one, and install the driveshaft (Refer to DRIVESHAFT ASSEMBLY ).