>> A << Differential Carrier Assembly Installation
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Check that the length of the electronic control coupling stud bolt (A) is within the standard value range.
Standard value: 21.6 - 24.4 mm (0.86 - 0.96 inch)
- If the length exceeds the standard value, replace the stud bolt.
Tightening torque: 15 ± 3 N.m (11 ± 2 ft-lb)
NOTE: When replacing the stud bolts, always clean the stud bolt threaded holes.