LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Rear Axle - AWD) >> Differential Carrier Assembly >> Reassembly >> Reassembly Service Points >> >> G << Drive Gear Installation

>> G << Drive Gear Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove adhesive on the drive gear tightening bolts.
  2. Use a tap to remove adhesive in the drive gear screw holes, and clean the holes by blowing air.
    Fig 1: Removing Adhesive On Drive Gear Tightening Bolts
    G09665808Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Apply the specified adhesive in the drive gear screw holes.

    Specified adhesive: LOCTITE No.271 

  4. Align the mating marks and assemble the drive gear to the differential case.

    Tightening torque: 41 ± 5 N.m (30 ± 3 ft-lb) 

    Fig 2: Applying Specified Adhesive On Drive Gear Screw Holes
    G09665809Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals