LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Rear Axle - Fwd) >> On-Vehicle Service >> Hub Bolt Replacement

Hub Bolt Replacement

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caliper assembly and the brake disc. Retain the caliper assembly with a wire and the like to prevent from falling.
  2. Use special tool hub bolt remover (MB991618) to remove the hub bolt.
    Fig 1: Removing Hub Bolt Special Tool Hub Bolt Remover
    G09665700Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. After fixing the hub using special tool front hub and flange yoke holder (MB990767), install the plain washer to the new hub bolt and tighten the bolt with a nut.
  4. Install the brake disc, caliper assembly and tighten the caliper assembly mounting bolts to the specified torque.

    Tightening torque: 58 ± 7 N.m (43 ± 5 ft-lb) 

    Fig 2: Installing Hub Bolt
    G09665701Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals