<< C >> Self-Locking Nut (Tie-Rod End Connection) Removal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Loosen the self-locking nut (tie-rod end connection) from the ball joint, but do not remove here. Use the special tool.
To prevent the special tool from dropping off, suspend it with a cord.

Install special tool ball joint remover (MB991897 or MB992011) as shown in the figure.

Fig 1: Installing Special Tool Ball Joint Remover (MB991897 Or MB992011)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Turn the bolt and knob to make the special tool jaws parallel, then hand-tighten the bolt. After tightening, check that the jaws are still parallel.
NOTE: To adjust the special tool jaws to be parallel, set the orientation of the knob as shown in the figure.

Fig 2: Checking Jaws Parallel
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Unscrew the bolt to disconnect the ball joint.