>> A << DYNAMIC DAMPER/DAMPER BAND INSTALLATION < 3.0 L Engine (LH) >
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
There should be no grease adhered to the rubber part of the dynamic damper.
- Install the dynamic damper in the position (A) shown in the figure.
A: 231 ± 3 mm (8.3 ± 0.1 in)
- Secure the damper band.
- Wrap plastic tape around the shaft spline, and then install the PTJ boot band (small) and PTJ boot.