Inspection Procedure 7: When The Cruise Control Switch is Operated, The System is not Turned ON: Operation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

This circuit judges the signals of each switches (cruise control ON/OFF, CANCEL, SET - and RES +) of the cruise control switches. The ECM detects the state of the cruise control switches by sensing the voltages shown below.

When all switches are released: 4.7 - 5.0 volts
When the cruise control ON/OFF switch is pressed: 0.9 - 1.7 volt
When the CANCEL switch is pressed: 1.9 - 2.7 volts
When the SET - switch is pressed: 2.9 - 3.6 volts
When the RES + switch is pressed: 3.8 - 4.5 volts